Notifications
Clear all

Reloading your M/L (in the field)

18 Posts
9 Users
0 Likes
4,815 Views
Iluv2hunt
Posts: 12399
Topic starter
(@iluv2hunt)
Illustrious Member
Joined: 18 years ago

How do you guys reload your m/l's, right after a shot? I read a lot of reports where guys make a shot and reload their gun within seconds...
I really need to improve my method. It is simply not fast enough

I carry one of these, along with primers in the slots and a capping tool. (one of my guns, you have to use the capping tool, the WOlf you don't). I used to carry it in a plastic baggie in my back pack, but since started carrying it in a pocket that's quickly accessible

17 Replies
Cr0ck1 (Beagler)
Posts: 14758
(@beagler)
Illustrious Member
Joined: 18 years ago

I carry the same thing.

Reply
Kortsman
Posts: 1116
(@kortsman)
Noble Member
Joined: 17 years ago

I carry the speed loaders along with T-handle pusher that pushes the bullet down about 3 inches. Then I use the ramrod to finish seating it. Hardest part is starting the bullet with just the ramrod. Once it's in the barrel a few inches, it's easy to seat.

Reply
Cr0ck1 (Beagler)
Posts: 14758
(@beagler)
Illustrious Member
Joined: 18 years ago

I carry these three things. The black tool is to remove the primer. For some reason after the shot my primer gets stuck and I've had to use a plyer to remove it.

Sent From Cr0ck1' IPhone most likely from the woods.

Reply
Iluv2hunt
Posts: 12399
Topic starter
(@iluv2hunt)
Illustrious Member
Joined: 18 years ago

The black tool is also to put a new primer on (other end of it). I have to use it with my older inline. It's a bolt action and the breech plug is a bit recessed so its impossible to get fat fingers in there to put a primer on. With my Wolf, it breaks open and the primer is easy to get to

Reply
Page 1 / 4
Share: