Lube and casings

It will come out...get a bigger hammer! Clean the brass before you size ... lube the mouth of the case.

Once you drive the case out of the die, use a pipe cutter to cut the case in half, drop out the decaper and pin.....

http://leeprecision.com/stuck-case-removal.html

http://www.ar15.com/content/page.html?id=463

Pipe cutter!! Actually got a small one! Never thought bout that. Ill work on that tomorrow.

Sent From Cr0ck1' IPhone most likely from the woods.

Put the lock nut on loose, drive the pin with a punch the brass will drive out of the die. Cut the case in half with a hacksaw or pipe cuter......don't mess around trying to save ruined brass.

Did I tell you to use more lube...put a tiny bit in the case mouth?

Sorta like...need more cow bell!

Man might mess up the pin banging on it like that.

Got it out but mushroomed the top of the decapper. Now crimp nut wont fit back on! Lol should i run it on a grinding wheel so i can flatten out the mushroom?

Sent From Cr0ck1' IPhone most likely from the woods.